[WRX-maniac]

Ok, so I did some research and answered a couple questions on my own, but it lead to a few more that I absolutely cannot figure out.

So my car will need to have the restrictor pill put back in the hose in order build boost adequately.
Ok, so the hose that came with the grimmspeed ebcs, can I resuse it? Is the hose diameter the same as stock? I believe the hose is 1/8 inch from grimmspeed. Is the stock hose the same size? Does it matter?

Last question, what size is my restrictor pill!!?? I have found them to buy, but sizes vary from 0.5mm to 1.0mm. I cant find anything online that goes higher than 06-07MY to tell me what size I need. Any help is appreciated here!!!!

 

[WRX-maniac]

Ok so im confused. Refer to the picture in the link below. The section 14447 is the hose and T section. The right (turbo side) of that T is where the restrictor pill is suppose to go. This diagram is 09-14 specific. There is no restrictor pill in the image or offered to buy in the parts list below.

2011 Subaru WRX 2.5L TURBO 5MT 4WD. #14447AA320: HOSE ASSEMBLY-TURBOCHARER

Compared to the lets see the 2007 wrx diagram for the same area. It physically shows the restrictor pill in the diagram with the part number of 22326AA260. According to Subaru, they refer to this part as "Orifice-A".

http://parts.subaru.com/p/Subaru__/ORIFICE-A/49231643/22326AA260.html

I don't get it, does my car not come stock with a restrictor pill then??? Per Grimmspeeds instructions it specifically states to "remove the factory restrictor pill".

I am beyond lost.......??????

 

[WRX-maniac]

I figured it out. Not much about it on the interwebz. I just learned a whole lot about restrictor pills in the last hour and a half. haha