Subaru WRX Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi guys, I got an issues that's confusing me, I bought a 2008 wrx sedan and when I got it the transmission wont go into gear only when its turned off, so I bought a new master and slave cylinder, installed them, did fluid change for the transmission, now when I drive it first 10 miles it shifts perfect, after that I start to get a slight grind in 3rd gear when I shift fast, any idea what that could be ??? I was thinking when the sinco is going bad it would do it all the time, not just when cold ??
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top