ClubWRX Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
Hello all,

I recently bought a 02 WRX and the clutch started going bad in it just one month after i got it. I purchased a F1 Racing Stage 3 clutch and flywheel. They were professionally installed. Now it's been 1000 miles so they should be all broken in since i put it in. Whenever i Rev my engine up to high RPMs before i shift the clutch will sometimes go all loose feeling. Like i can push it down 1/2 - 3/4ths the floor until there is any tension. I am wondering what is wrong here? After like 10 mins if i just drive normally the clutch will tighten back up. Back to how it is normally. I'm now sure what the problem is.

Thanks for some advice.
 
1 - 1 of 1 Posts
Top