ClubWRX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
223 Posts
Discussion Starter #1
Guys I purchased whiteline endlinks for my car earlier this summer and lastnight while Cody and I were doing a brakejob to my horror we found that the passenger side front endlink poped off of my Cobb sway bar leaving only the bushing attached to the sway....would this be a defective endlink or do you think I need to get bigger washers and put them on both sides of the bushing (Cody's first idea)....and yes I would post a pic of it but sadly my PC isnt hooked up at my new place and im posting this at work.....

but back to the point has this happened to anyone else or are there any other fixes that I should look into also since we're gonna have the car torn apart this weekend anyways.....(and yes I already tried searching to no avail)

Thanks,
Dave
 

·
Registered
Joined
·
505 Posts
My Whiteline endlinks came with new hardware(bolts, locknuts & washers). Did yours not include new hardware?

Whiteline makes prety good stuff. I'd think it's a defective part.
 

·
Moderating on the run!
Joined
·
12,477 Posts
It's fairly common for folks to miss a washer on the install- w/o the washer the bushing simply pulls out. I'd have to see pics to confirm, but this has happened to lots of folks (and not just w/ WL) where the bushing is pulled out w/ no washer to retain it.
 
1 - 4 of 4 Posts
Top