Subaru WRX Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I just istalled the joe p mbc and an autometer boost gauge


i have it set at 15psi right now

WOW what a difference i love it



the mbc took 5 mins i timed it


the boost gauge took 25mins


ill post pics later
 

·
Registered
Joined
·
110 Posts
I also installed and tuned my MBC yesterday. It was quite simple, however dialing it in took me a little more than two hours.

It peaks in fourth at 0.107 megapascals :) which is ~15.5 PSI.

Had a question...where did you all mount the device?
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #4 ·
here is some pics of my Joe P mbc installed and where i tapped for the boost gauge








and now i feel the POWER
 

·
Registered
Joined
·
3,501 Posts
I mounted my Joe P with a zip tie to the black bracket above and to the left of the turbo. It has a square hole in it and holds the boost controller quite securely.

-Jim
 

·
Registered
Joined
·
110 Posts
That was actually PlatinumWRX who said that...I just quoted him.

But I found that empty hose clip also and mounted mine there too. VERY convenient. And kinda stealthy too.
 

·
Registered
Joined
·
66 Posts
Sorry about that SI2WRX. Ment to refer to Platinum's post. I'm glad you like the location. It works great for initial setup and when further adjustments are needed since the bracket holds it nice and tight.

Shawn
 
1 - 9 of 9 Posts
Top