ClubWRX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
Ok im at work alone and the water jug on the water cooler just ran out. I have never replaced one before so i don't want to like spill water everywhere. Could anyone by any chance give me a step by step haha.
 

·
The Legendary Bad Ass (aka; Buzzz)
Joined
·
5,400 Posts
Take the dang top off of the new one and make sure the palm of your clean hand is over the cap. Lift it up and almost in place before you let your hand off the top. It is really not that difficult to stop the leaks with the one hand. And once it is almost in place, and the opening is over the open area into the cooler, let the hand go and straighten it out, and it will 'glug' until it hits siphon point.
good luck.
 
1 - 3 of 3 Posts
Top