Subaru WRX Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #1 ·
They are located on South Huntington in Roxbury. Has anyone in the Boston area had or heard of any experiences with them? :confused:

I am looking to have my Defi gauges put in there.

Thanks,
Brian
 

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #2 ·
Defi gauges installed

I got my gauges installed here and they did a good job. They were quite a bit cheaper than other shops in the area.

They also purchased a silver sedan and are planning on doing quite a bit of work on it. So their knowledge of the car should grow....hopefully :)
 

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #4 ·
Sti Spec-C said:
I was just there this afternoon and from what i saw that place is pretty nice. the prices are cheaper than the other shops around the area and they know what they are doing. I'm going to have my GC8 2.5RS converted to a JDM WRX over there pretty soon and I hope that I'll get the same results as the S15 that I saw sitting outside today.
Well that is quite an undertaking. Please keep us in formed. I am very interested to hear about this project.
 

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #6 ·

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #11 ·
Trailboss said:
Oh nice, so they did your gauges to assist in the tuning of your car when you do your GT30R kit, right? :wiggles:

*in constant persuit to make Brian mod*
Look at the date of that post on gauges. ;)

Who said I was going to do a GT30R? :D
 

·
Registered
Joined
·
4,020 Posts
Discussion Starter · #16 ·
faylix said:
Get that quote in writing and make him stick to it. My turbo kit for my integra type R was only susposed to run 4,000... it went up another 600 dollars inexplicably when it was time to pickup the car.

-J
Definitely get that in writing. Remember cheaper isn't always better. Just make sure you are clear on all the expectations.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top