Subaru WRX Forum banner
1 - 20 of 28 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 · (Edited)
These are nice!
Top Gauge
Air intake temp/Coolant temp
Middle gauge
Fuel Pressure/Oil Pressure
Bottom gauge
Boost/EGT

I removed the original interior shot. 12/8/02
Posted diferent one below.
 

·
Registered
Joined
·
7 Posts
I've been promoting SPA gauges for months... ever since I first layed eyes on them while searching for rally display packs.

Glad to see someone get them I know I will have them in my project car.

Just hope they don't become too popular so that they are special...

6 readings for the price of 6 autometer guages or less and all sending units and such included.

Thanks - Jon
 

·
Registered
Joined
·
1,212 Posts
WOW, those are really nice. I was planning on going with Defi gauges, but the ability to monitor six engine parameters for about the same price as three with the Defi is nice.

Are they easier or harder than dial gauges to read at a glance?
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #11 ·
Coolant temp sensor before being installed.
Was just monitoring underhood temp for the last week.
It's now hooked up.
If you follow the wire back you can see the waterproof
connection to the gauges wiring harness.
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #15 · (Edited)
Here's a diffrent pic from inside.
I can't get my camera to foucus verry well.
They look better than this.
Top Gauge
Air intake temp/Coolant temp
Middle gauge
Fuel Pressure/Oil Pressure
Bottom gauge
Boost/EGT
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #19 ·
very nice. what guage pod are you using for these guages?
That's the Autometer 3 gauge A-Pillar.

I would rather of put them on the dash where the clock is but
Could not find a good pod for 2-1/16" gauges.

On the A-Pillar the top gauge is to close for me to focus
On easily.
 
1 - 20 of 28 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top