ClubWRX Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
181 Posts
Discussion Starter #1
starting to run RCAs, speaker and power wire for my amp in the trunk. does anyone know how to get it pass the back seat without messing up my car?
 

·
Moderating U!
Joined
·
6,318 Posts
Take out the back seat cushion(the one you sit on). Unbolt the 4 bolts that hold the back seat back, lift it up a bit, and feed the wires underneath where the arm rest comes out of the back seat. Bot everything back up nice and snug when you are done. Then you are GOLDEN.

I did the same thing with my MTX amp and Bazooka subwoofer in my car.
 

·
Registered
Joined
·
181 Posts
Discussion Starter #3
KurleeDaddeeWRX said:
Take out the back seat cushion(the one you sit on). Unbolt the 4 bolts that hold the back seat back, lift it up a bit, and feed the wires underneath where the arm rest comes out of the back seat. Bot everything back up nice and snug when you are done. Then you are GOLDEN.

I did the same thing with my MTX amp and Bazooka subwoofer in my car.
ditto :)
 

·
Registered
Joined
·
10 Posts
Does anyone have instructions or pictures, how to run the amp power wire from the battery through the motor shield?
 

·
Registered
Joined
·
72 Posts
It's really easy, run it through the grommet, down the driver side door sill, under the rear seat and into the trunk. I put the stereo in mine.
 
1 - 9 of 9 Posts
Top