Subaru WRX Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I'm trying to ohm out an ABS sensor on my 02 WRX without crawling underneath the car. I have the pin-outs for the connector that plugs into the ABS control module (located behind the right headlight) but don't know how to disconnect the connector. Does anybody know how to unhook / release the connector? Thanks in advance.
 

· Registered
Joined
·
8 Posts
Discussion Starter · #2 ·
I solved it (in case anybody needs this thread in the future). There's a little "handle" that sticks out from the back of the connector (near the wheel well). Using a screwdriver, you can pry (or prise if you're in England!) that handle to the back. Keep going and it'll slide all the way back, then the connector comes loose. Simple !!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top