ClubWRX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Ive recently acquired a CEL on my 2004 WRX. Ive done some searching and it seems that the only way to retrieve the fault code is by using a code scanner of some sort.

Is there a manual way to pull the code from the ECU?

I could put my MR2 in a diagnostic mode and it would flash the check engine light and give the code(s).

TIA.
 
1 - 4 of 4 Posts
Top