ClubWRX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
I am converting a 2003 WRX transmission from pull clutch to push clutch. I am using a Tilton pull slave cylinder to change the direction of the fork.

Question:
Is there a T.O. bearing that will mount to the pull fork with or without modification to the fork?
 

·
Super Moderator (Actually a SuperSpy)
Joined
·
29,217 Posts
Tilton offer hydraulic throw out (release) bearing kits. Contact them directly I'd say. Jeg's sells Tilton but I don't know whether Jeg's would know the answer. Tilton should know.
 

·
Registered
Joined
·
27 Posts
Discussion Starter #4
I am converting it to run a 5-1/2" or 7 -1/4" dual disc carbon Tilton or 10,000 RPM clutch. There is nothing available in a light weight race clutch that uses a pull clutch.

The pull clutch fork, that uses the cross bar pivot, is much stronger than the sheet metal push fork that works with the ball.
 
1 - 5 of 5 Posts
Top