ClubWRX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
630 Posts
Discussion Starter #1 (Edited)
I got a set of Progress springs that I'm in the middle of installing and I could use some help. I've got the drivers side off and disassembled so far but before I get any further I've got a couple of questions:

1. I didn't get any instructions with the springs so I don't know if I'm supposed to cut the bump stops, and if so where?

2. I had to push down the dust cover to grab the strut to keep it from turning when I was taking the top bolt off, and consequently, moved the bump stop. Now I have no idea where it belongs. Logically I think it goes right at the bottom (see below post with pic). I just want to be sure before I re-assemble this thing.

I searched and couldn't find anything on this subject. Thanks for the help!

Koji
 

·
Registered
Joined
·
630 Posts
Discussion Starter #3
ok - I figured out by looking at the other ones that the bump stop must go on top. Still not sure exactly how. do i need to cut them!? HELP!
 
1 - 7 of 7 Posts
Top