ClubWRX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Ok, after applying Dynamat to my drivers side door, I noticed that my power door locks no longer worked. I peeled off the Dynamat where the 2 rods are located and tried the locks again, nothing! They don't work when you push the button on the door or by keyless entry. Does anyone know what might have happened or is there anyway to reset the locks? Any help is very appreciated! Thanks!
 

·
Registered
Joined
·
3,717 Posts
did you maybe disconnect the wires (or harness) that goes to the switch by mistake?? Or maybe while doing your dynomat install, you might have shorted something out thus blowing a fuse.

That's what I would check first, then go from there.

I know this may sound stupid but did you press the lock botton that disables all other doors from controling the windows? Just a thought.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
The fuse was blown. Thanks for the help. I think the rods were rubbing something on the panel which caused the fuse to blow.
 
1 - 5 of 5 Posts
Top