ClubWRX Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
317 Posts
Discussion Starter #1 (Edited)
if u lowered ur steering rack for the bushing install, how did u move it back, i have it lined up correctly and about half way on, but it just wont move any further and the small lip below the cut out at the end of the column is preventing the screw from goin in, did ur rack move easily on the coulumn?

THIS IS URGENT!!!
 

·
Registered
Joined
·
353 Posts
i did not lower the entire thing. i undid both sides and then when putting the new ones in, i pulled down on the axel, and then pryed the steering lines for the driverside, and also moved the little clip around to get the mount off the stock bushing and then back on the new one.
 
1 - 2 of 2 Posts
Top