ClubWRX Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
567 Posts
Discussion Starter #1
We installed a slightly used set of Tein Flex's on my buddy's car last night. He had also bought a used EDFC with it. Everything is wired up correctly. When we power up the EDFC, the starts blinking and saying that there is an error in the rear setup. I looked in the manual and all it says is to make sure everything is connected. We check 3 times and verified everything was connected properly. I know there's a possibility that one of the rear motors might be shot but is there anything else I can do to prove that or to see what else might be the issue? Thanks
 
1 - 1 of 1 Posts
Top