Subaru WRX Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
17,861 Posts
Discussion Starter · #1 ·
Hi All,
I just installed the Corbeau CR1 seats into the car :)
and i was wondering if anyone here knew what resistor size to use to turn off the Airbag light ?

Any advice peeps ??

Thanks
Andy....
 

·
Registered
Joined
·
277 Posts
airbag light

i just orderd seats myself... and i have not yet installed them...

but i was hoping that pulling off the fuse will work... ? let me know if it does.. or i'll let u know when i do mines
 

·
Registered
Joined
·
36 Posts
link doesn't work.

Is it an 8ohm resistor then? I read that a 3.3 would work, but I tried it and it didn't
 

·
Super Moderator (Actually a SuperSpy)
Joined
·
19,763 Posts
What is the value registered when you measure across the two terminals on the *seat* side of the connector? That's what you're shooting for.
 

·
Registered
Joined
·
36 Posts
Re: airbag

20wrx02 said:
do what i did pull the bulb out ... simple
yes, that would work, but not quite what I had in mind :D
 
1 - 7 of 7 Posts
Top