ClubWRX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Im trying to raise the whole car to do my shifter bushings. Where are the jacking points and how should i start? Jack one side put it on jack stands then jack the other?
 

·
Registered
Joined
·
2,663 Posts
Run into wall, have car run into back of you. The front and rear will be all jacked up

Oh wait.....
 

·
Registered
Joined
·
479 Posts

This guy can help.
 

·
Registered
Joined
·
316 Posts
1. drive front end up on ramps
2. place floor jack under rear differential and raise car
3. place jackstands under rear of car
4. place jack under front crossmember at rearmost end of under shield
5. raise front of car off ramps
6. place jackstands under front of car
 

·
Æternum
Joined
·
20,571 Posts
A good jack point is on your subframe.
 
1 - 7 of 7 Posts
Top