ClubWRX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
I have a universal harness bar and 2 4 points from NRG. Pretty nice looking equipment at a good price. I need help installing these and was wondering if anyone has a guide to this?
 

·
Registered
Joined
·
6,751 Posts
Basically you need to figure out where the bar length is correct to attach to your B pillar. Remove the trim from the pillar at that point and attach the bar. This needs to be up towards your shoulders, about 2" below them. If the bar length is correct that's where it will end up. Cut the trim for the pillar to fit the bar and you're done.
 

·
Registered
Joined
·
6,751 Posts
It needs to mount to the solid metal of the unibody of the car in order to do its job. If you mount it to/through the trim, you're not going to get a solid mount.
 
1 - 4 of 4 Posts
Top