Subaru WRX Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
223 Posts
Discussion Starter · #1 ·
Anyone recommend a good brake shop to install stainless lines and pads for me?

I would do it at the install fest, but my brakes really suck, and it's a lot of work from what I hear. I don't want to inconvenience anybody with such a big job since I sure don't know how to do it myself.
 

·
Registered
Joined
·
204 Posts
Last I checked, the brakes weren't that hard to do. Heck, I've seen it done plenty of times, in-between ferrying drinks to the techs.

Nick C.
 

·
Registered
Joined
·
91 Posts
It's easy. We did mine with minimal heartache. The worst part was bleeding the brakes.
 

·
Registered
Joined
·
204 Posts
Dizzy said:
It's easy. We did mine with minimal heartache. The worst part was bleeding the brakes.
And I watched!

Nick C.
 

·
Registered
Joined
·
91 Posts
Don't be so modest. As I remember, you were in charge of the fluid level in the master cylinder. Bang-up job, BTW.

:)
 

·
Registered
Joined
·
470 Posts
Yeah it's a fairly easy job... I helped a friend on here with his the work took about 1.5hrs mostly because we were all too dumb to figure out how to get off one clip... (first wheel took 45 min) after taht it went quick... would have been even better with a lift and something better than the stock lug wrench.
 
1 - 7 of 7 Posts
Top