Subaru WRX Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I'm switching to ECUTek as i've been getting the wonderful P0420 code from my high flow j pipe and also planning on going Stage 2+ in the near future. One thing i'm not sure is how to setup the Connect app to mimic what I was monitoring on my AP before. i've found DAM but i'm not sure what the equivalent would be for Feedback Knock and Fine Knock Learn. there are only a couple knock parameters listed so i'm assuming they are the same. If anyone has some tips for the transition that would be great.

Thanks.
 

·
In Æternum
Joined
·
17,118 Posts
Can you post a list of logging parameters?

With the older, open-source defs FBKC and FLKC were the knock learning parameters.
 
1 - 2 of 2 Posts
Top