ClubWRX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
So I have started collecting some spare parts, right now I have an extra intake manifold, and exhaust manifolds. I was going to start porting and polishing these but I was wondering if its ok to just use Autozone or Carquest gaskets to gasket match them or at least to make sure I dont go to big. Or should I just go and get the actual ones from subaru... I was going to just use these gaskets strictly for the purpose of P&P. When I install everything Im going to get the grimmspeed gaskets.

-Dave
 

·
Super Moderator
Joined
·
33,822 Posts
Subaru or GrimmSpeed. Why do want to use Autozone, etc.?
 

·
Registered
Joined
·
42 Posts
Discussion Starter #3
I asked because there is a carquest and AZ right next to my house. Its not a big deal, Ill just go pick up some stock subaru ones on my way to work. I work as a machinist so I will be porting everything at work after hours anyway.

Thanks for the speedy response.
-Dave
 

·
Super Moderator
Joined
·
33,822 Posts
The GS gaskets are just as good as OEM, yet a bit cheaper. Those are the only two I'd consider.

Good luck. :)
 
1 - 5 of 5 Posts
Top