ClubWRX Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter #2
I just checked out PDE downpipe on Oakos Automotive and it said

"Will fit any aftermarket cat-back exhaust system that is made to install on the stock downpipe"

Do you think this is the best fitment for the donut flange on the Espelir JGT 500 Catback????
 

·
Registered
Joined
·
34 Posts
i have an espelir on my04 sti.
it mates perfectly to stock dp w/ no problems.
i then tried having a perrin dp installed and it would have taken too much tweaking and probably the use of more than one gasket to fully seal.
the espelir uses the sliding flange and has a taper to accomodate the use of the stock donut gasket.
dp's that also use this off the top of my head:
pde
cobb
autospeed
daddys w/3ce
stromung w/ 3rd cat pipe or race pipe
 

·
Moderating YOU, before you had your Subaru!
Joined
·
13,353 Posts
pjdwrx said:
Verdugo has it on his car, even though he hasn't updated his profile. :p
Haha oops...yeah see mod list...
 

·
Registered
Joined
·
144 Posts
Discussion Starter #6
thanks for the reply.. i'm definitely going to buy the PDE downpipe. I don't wanna waste my time buying gaskets and trying to figure out why my stuff still leaking. i know PDE is expensive but its worth it.
 

·
Moderating YOU, before you had your Subaru!
Joined
·
13,353 Posts
Nope, because Blitz piping sucks. :D
 
1 - 8 of 8 Posts
Top