Subaru WRX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
So i did a engine swap on my bugeye & after putting everything back together the clutch petal just falls to the floor. it just feels like there is no pressure in the system. The slave still feels soft & i can push it in by hand.
Bled & bled it.. then bled it some more. no change
I can move the clutch fork & feel the pilot bearing going in & out.

Replaced the slave Cylinder No change
Replaced the Master cylinder No Change
Replaced the rubber line with a steal braided . No change
Replaced the slave again. NO change
Replaced the Hard clutch line. No change

So im scratching my head to why it will not hold?
i have replaced everything

The way i am bleeding is:
Pressing in the clutch
open nipple
close nipple
Release clutch
repeat.

Have allso tried the pumping method
 
1 - 3 of 3 Posts
Top