ClubWRX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Installed a TurboXS topmount and now 1 weeek later I keep getting code 1507. I know it's idle control malfunction. All connections at the throttle body are good. Any ideas?
 

·
Registered
Joined
·
404 Posts
Thats interesting...I just had that same code pop up this weekend after my car was sitting a couple days. I only have IC hoses and a reflash...I reset the ECU, and started it up a couple times to see if it could set the idle properly, but it kept going into some sort of limp mode. So I was driving to a dealership to get a diag. done and figure out what was up, and it started to run smoothly after it warmed up...so I stopped, cleared the CEL, and restarted the car and it hasn't come back since. I'll have to burp the coolant system just to check...but could it be a sensor is starting to go?
 
1 - 3 of 3 Posts
Top