ClubWRX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter #1 (Edited)
I got the CEL P0365 camshaft position sensor (bank 1). Now the problem is I don't know exactly where is the position sensor located?? I currently have a EJ207 on my 04 WRX.

Please really need help on this. I've had this code for a month now with no success in taking it off.

Thanks guys, Happy holidays.
 

·
Registered
Joined
·
118 Posts
Discussion Starter #2
anyone????
 

·
Premium Member
Joined
·
6,501 Posts
No offense,but have you even tried Google? If it is a true Ver7 longblock swap then there are two sensors. The sensors are on the top of the heads right behind the intake cam gears. Takes 5 minutes to remove a sensor. If it is just a shortblock swap then it's the same for any USDM 2.0L WRX. One sensor behind the drivers side intake cam gear. Also there is no need to make multiple threads asking the same question. Just bump your original thread.
 

·
Registered
Joined
·
118 Posts
Discussion Starter #4
Yes, i've googled it. I have a ver8 complete swap, and I know there are two sensors in a ver8 and that one sensor is behind the cam gears but thats on bank 2. I'm looking for the sensor in bank 1, left side.
 

·
Registered
Joined
·
118 Posts
Discussion Starter #6
OK, thank you. I had no idea. --- Do you know by the chance if an EJ205 sensor will work on the EJ207?? If not sure, what the worst that can happen if I just test it out by simply installing the wrx one for a few minutes?


thanks
 

·
Premium Member
Joined
·
6,501 Posts
Should be pretty easy to tell when you pull the sensor......
 
1 - 7 of 7 Posts
Top