ClubWRX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter #1
well today i was installing my new perrin turbo inlet, and my crankshaft pully and when i pulled my IC off i noticed that i had a big piece of plastic broke the runs from the firewall to the top of the engine/trany. could someone tell exactly what this thing is/does and should i try and find a better one that one looked kinda cheep and just snapped in half, i dont know how long it been like that but im sure it aint to good.what effects could the casue being broke?
 

·
Premium Member
Joined
·
11,095 Posts
What year car is it?

You can go to kartboy and get an engine pitch from him. It's beefier and metal.

The purpose is to not let the motor flex all over the place. I'd get it replaced before long.
 

·
Registered
Joined
·
41 Posts
Discussion Starter #3
oh my bad its a 06 STi, is it common that this POS plastic breaks or did i really screw something up?
 

·
Premium Member
Joined
·
11,095 Posts
oh my bad its a 06 STi, is it common that this POS plastic breaks or did i really screw something up?
The 06's had motor mount issues when they were first released. If that mount broke I'd look into the engine mounts as well.


I wouldnt fret it honestly...just get it replaced.
 
1 - 4 of 4 Posts
Top