[Blackdragon1400]

I just installed the Stage 1 93 Stock Performance Map with normal wastegate, I thought the target boost in S# was 18 PSI, but I'm just shy of 15. My max boost on the stock map was 17 PSI. I'm not entirely sure how to read boost error other than "Around 0 at 100% throttle is good". Comments are welcome: https://docs.google.com/spreadsheets/d/10b3VW8_6p0kSmr6UepWURywJLwUE4hPWsWLRMTs4-7I/edit?usp=sharing There's a short pull on the second sheet and charts on the 3rd.

 

[EJ257]

I'm not going to parse through your datalog...

3rd gear
2000/2500-Redline (WOT)

Also, what vehicle?

 

[Blackdragon1400]

2016 STI, Stock.

A question since you brought it up, in 3rd gear is WOT around 3k RPM not recommended? I know going WOT in higher gears at low RPM is stress on the engine, but I thought 3rd was low enough (at least the car didn't 'feel' like it was straining). FWIW one reason I started logging was to improve my driving so any and all advice is welcome.

 

[EJ257]

2016 STI, Stock.

A question since you brought it up, in 3rd gear is WOT around 3k RPM not recommended? I know going WOT in higher gears at low RPM is stress on the engine, but I thought 3rd was low enough (at least the car didn't 'feel' like it was straining). FWIW one reason I started logging was to improve my driving so any and all advice is welcome.

It's fine to start there other times, but for the purposes of troubleshooting the issue you're having, start 2-2.5K RPMs

 

[Blackdragon1400]

It's fine to start there other times, but for the purposes of troubleshooting the issue you're having, start 2-2.5K RPMs

Thanks for the advice on how to correctly test this, looks like after 3.5k RPM boost error is almost zero throughout the pull. Topped out at 17.7 PSI.