ClubWRX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
Just installed the Cobb SF Intake and Access Port. When I tried running Stage 1 93 Octane + the Intake Map, the RPMs would not go over 4000 without the car shaking violently. So now I'm running just Stage 1 without the intake map and the car is running fine. I've tried re-installing the intake map with no luck and the car still will not run right. Just wondering if anyone else has these 2 mods and has run into the same problem. I'll take any help I can get!
 

·
Master Baiter
Joined
·
22,114 Posts
Is the intake installed properly?
 

·
Registered
Joined
·
19 Posts
Discussion Starter #3
Everything was hooked up properly as far as I know. I made sure all of the hoses were tight and the mass air flow sensor didn't hit anything on the way out or on the way in on the new intake. Any ideas? I can always go back and check everything over again.
 
1 - 3 of 3 Posts
Top