ClubWRX Forum banner

1 - 2 of 2 Posts

·
Registered
Subaru WRX 2012
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Hi everyone new to the forum. Im in a bit of a stump here. Yesterday I got out of work started my car up and my check engine light was flashing at me. I ran the codes using my AP and got the following:

P0851 (Neutral Switch Input Circuit Low)
P1152 (02 sensor circuit range/performance (low) bank 1 sensor 1)
P1153 02 sensor circuit range/performance (high) bank 1 sensor 1)
P1518 (starter switch circuit low)

  1. Along with the codes, when the car is in the run position, I can hear the fans switching between 3 different speeds. I believe that’s the car letting me know it’s in limp mode. I tried clearing the codes, disconnecting battery and pressing the brake, and checked all the wiring and can’t find a solution. Any help or insight would be very much appreciated!
 

·
Registered
Subaru WRX 2012
Joined
·
2 Posts
Discussion Starter #2
Nevermind. I figured it out! Diagnostic connector was plugged in under passenger footwell.
 
1 - 2 of 2 Posts
Top