Subaru WRX Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. General Maintenance, Troubleshooting & Accidents.
    Hey y'all. This is my first time ever posting in this forum. I'm new to car stuff and just recently installed the cobb redline cold air intake and the accessport. I'm running the 93oct stage 1 OTS tune for now. It was running just fine for the past week after installing. Never seen the DAM get...
  2. General Maintenance, Troubleshooting & Accidents.
    Hello all, I’m new to the subie world and I’m wanting an opinion on where I should start to track down my DAM and Feedback Knock issue. The dam dropped all the way down to .500, the highest Feedback knock I registered was -4.44 and that was at around 3000RPM. I’ve recently bought the car, has...
  3. General Maintenance, Troubleshooting & Accidents.
    Hey everyone, I’m new to the site and need some advice. I’m a bit inexperienced when it comes to access ports and such. I have a 2020 WRX base with 20k. The only thing I have installed is the Cobb stage 1+ Big SF with the OTS tune. I was driving home this evening and I noticed the DAM dropped to...
  4. Engine Modifications
    I have a 2015 wrx base and recently bought AP for it. I finally got into the workings of how and what to use on it and when I pulled up my DAM it dropped too .850 then some more and more and came back up and is now hovering around .688. It threw a history fault code a while back that I had...
  5. Engine Performance
    Hey all! New here, but glad to have knowledgeable people to help a brotha out. I have a 2016 wrx, I have installed a remark aftermarket exhaust, Cobb big sf intake, and the access port, running the stage 1+ Bigsf intake OTS map. My DAM was at the nice and pleasant 1.000, but as I was driving my...
  6. General Maintenance, Troubleshooting & Accidents.
    2017 Subaru WRX 2.0 Manual. Log - datalog42 My issue started after I fixed a jumped timing on the passenger side exhaust sprocket. After the timing issue was fixed, I noticed the occasional negative FBK, FKL, and DAM drops. It was so bad that the DAM would sometimes reach .3 and I would feel a...
  7. Dam

    Tuning: Electronic Engine Management
    I have a ej255. I bought the short block and I built the long block and put the engine in the car. Car is tuned on 93 @6star. Would someone please be able to help me trouble shoot something on the anxiety port? I had a check engine light on for a o2 sensor that went out I drove the car to work...
  8. General Maintenance, Troubleshooting & Accidents.
    Recently tuned my 2015 WRX 93 octane custom tuned by a good pro tuner about a month and a half ago. Today I noticed my DAM had dropped to .750 and I had a FNL of -7.38/.35. I lightly drove it to see if I could get it back up and managed to get the DAM to .835 and the FNL down to -5.63/.35. I had...
  9. General Maintenance, Troubleshooting & Accidents.
    Okay I should start by saying I have a 2016 WRX which I purchased used. Has 84k miles currently. Now when I got it I checked it over scanned for codes found no issues. The acceleration wasn’t smooth but I didn’t pay any attention 3-4500 rpms you could feel the power. So got the car installed the...
  10. Tuning: Electronic Engine Management
    My car (2002 wrx) was pulling -11.95 fine knock under daily driving circumstances like slowly accelerating at a light. The ecu was reset and now there is the occasional-2.11 feedback knock and fairly low knock learn numbers (-1.76) but now the DAM is low which I know after a reset is normal...
  11. New Member Introductions
    Hi I'm new here and I've had my WRX a little over a year now, with no problems whatsoever, but recently the DAM dropped dramatically from 1 to .850 to .725 to .500 and now its at .688 with feedback knock and fine knock learn appearing randomly at -1.45 at start and when given little more than...
1-11 of 11 Results
Top