ClubWRX Forum banner

Recent content by Ash02WRX

  1. loose belt

    General Maintenance, Troubleshooting & Accidents.
    When I start my 02'WRX cold it has been making a squealing noise lately. It will start squealing after a few seconds and then if I push the clutch in a few times it will usually stop. Then I don't seem to have any problems with it until the next morning when I fire it up again. I was wondering...
  2. IF YOU HAVE A MISFIRE CODE ,PLEASE READ THIS!!!

    General Maintenance, Troubleshooting & Accidents.
    grounding turned out to be the issue I was having problems with my 02 WRX and cyl 3 misfiring. After replacing the spark plugs and running injector cleaner through the system a few times with no positive results, I was about to drop hundreds on new coil packs when I noticed a post about the...
  3. Cyl 3 misfire. Possible causes?

    General Maintenance, Troubleshooting & Accidents.
    Thanks for the reply. I sure as hell hope it is not the same problems that the link you provided was detailing. But I am concerned, because previously it was just a solid CEL, and recently it is a flashing CEL. As soon as it started flashing at me I got it home and now it sits in the garage...
  4. Cyl 3 misfire. Possible causes?

    General Maintenance, Troubleshooting & Accidents.
    I have had a problem with Cylinder 3 missfire on my 02 WRX for a while now. It started happening awhile ago, and every time I would do something like replace the spark plugs, fuel filter, tighten fuel hoses, the CEL would go off and every thing would seem good. Also of note is the first couple...
  5. Is my engine running lean

    Engine Modifications
    Thank you everyone for helping me understand this. I am new with the whole tuning aspect of my car and now that I have an Access Port I am eager to learn everything I can about the inner workings of my car. I can monitor and log the MAF, load, A/F ratio etc. but of course these numbers mean very...
  6. Is my engine running lean

    Engine Modifications
    I have the capability of data logging. I just need to know what the xx/xx means. In other words what should the ratio be? Is 14/9 too lean? etc.
  7. Is my engine running lean

    Engine Modifications
    I have a Blitz short ram intake, and Borla XR-1 cat back exhaust installed on my '02WRX. Now that I have a Cobb Access Port I can monitor my A/F ratio. I just don't know what the numbers mean. A subaru tec told me I should make sure it was not running too lean. How can I tell?
Top