Same thing:
Jacking up a 2011 WRX...
This is a discussion on How to jack up front and rear of a 2008 wrx? within the Tutorials & DIY forums, part of the Tech & Modifying & General Repairs category; Im trying to raise the whole car to do my shifter bushings. Where are the jacking points and how should ...
Im trying to raise the whole car to do my shifter bushings. Where are the jacking points and how should i start? Jack one side put it on jack stands then jack the other?
Same thing:
Jacking up a 2011 WRX...
--Anthony 2011 DGM WRX stg2+sf intake + custom front end deer mod!
Official Subie owner as of 01/10/11![]()
Stink Eye Mob #87
Bye bye Bimmer![]()
Hellooo '11 REX
This guy can help.
2011 WRX 5-Door WRB
Cobb AP Stage 1 - SPT Exhaust - Bayson R Lip - 30% Tints
2001 Audi TT - Sold
GIAC Stage 1 - Eibach Springs - Koni Yellows - Neuspeed Sways - Enkei EV5s - Borla Cat-Back - 3.2 Valance - DieselGeek Short Shifter - ModShack TT Intake - Vortex Spoiler - Vortex Skirts - Brembo Kit - 30% Tints
1. drive front end up on ramps
2. place floor jack under rear differential and raise car
3. place jackstands under rear of car
4. place jack under front crossmember at rearmost end of under shield
5. raise front of car off ramps
6. place jackstands under front of car
If you have a front lip be careful driving up a ramp.
Sent from my HTC PH39100 using Tapatalk 2
-Tony
2011 WRX WRB Stage2
2012 FXT DGM
The Big 2011/2012 Mod Thread
"Just Leave me alone. I know what I'm doing"- Kimi Räikkönen
A good jack point is on your subframe.
Zax' Shaggin' Wagon Build Thread Now tuned for 99% pure Unicorn Jizz!
Zach | Moderator -- Mid-Atlantic States, Tech & Modifying & General Repairs
The REAL 'WTF Tuning?!' Progenitor
Rollin' with the Bugeye Mafia #302 | N.E.R.D. Subject Zero | Blobeye Synd. #Tree-Fiddy
Facebook me here
Mods <---- drain savings account here
Originally Posted by Mikie13
Bookmarks