Romraider must have updated, but no Feedback Knock Correction (degrees) listed
Results 1 to 4 of 4

This is a discussion on Romraider must have updated, but no Feedback Knock Correction (degrees) listed within the Tuning: Electronic Engine Management forums, part of the Tech & Modifying & General Repairs category; It was fine, I restarted my comp and there was a whole list of stuff that wasn't there before. Everything ...

  1. #1
    Registered User
    Join Date
    Jan 2009
    Location
    Md
    Posts
    1,071

    Romraider must have updated, but no Feedback Knock Correction (degrees) listed

    It was fine, I restarted my comp and there was a whole list of stuff that wasn't there before. Everything that I used before was there, except for the Feedback Knock Correction (degrees). I don't know if there is another value I can check or what. I have redownloaded it yet again and now i'm just waiting for Eric from TP to get back to me and tell me what to check in it's place. I really do not like this program. It's given me a lot of problems as of late.
    2012 WRX: TurboXS DP, AEM CAI, TP stage 2 tune

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User
    Join Date
    Jan 2009
    Location
    Md
    Posts
    1,071
    Any ideas or what else can I check?
    2012 WRX: TurboXS DP, AEM CAI, TP stage 2 tune

  4. #3
    Master Baiter EJ257's Avatar
    Join Date
    Aug 2007
    Location
    On a stream bank somewhere
    Posts
    19,643
    I Support ClubWRX
    Is it connected to your car? If not, try when you are.
    2005 WRX STi (Mods | Virtual Dyno)

    Resident Tuner @ WTF Tuning, LLC

    "Never trust anything that bleeds for a week and lives ..."

    UNYSOC

  5. #4
    Registered User
    Join Date
    Jan 2009
    Location
    Md
    Posts
    1,071
    Quote Originally Posted by EJ257 View Post
    Is it connected to your car? If not, try when you are.
    Yes, that actually was it lol. However, when I went out and did 3 pulls, the program only logged 1 correctly... the other 2 were only 1kb. I HATE this program. I can't wait until this is done and then it's going to be a protune later on and that's gonna be that. The VD's numbers look a little more reasonable now, 333/371 @ 20 psi peak. I still think that's pretty high even for a dynojet, but oh well, the car feels good so far. I'm still getting that fluttering sound though. Boost is peaking at 20 and tapering to about 16 by 6700 rpms
    2012 WRX: TurboXS DP, AEM CAI, TP stage 2 tune

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •