Just picked up an 11' wagon that already had whiteline sways and endlinks. I was greasing the bushings because the previous owner failed to do so and they were squeaking like crazy. Anyway while I was underneath there I found a rear endlink to be busted. Also seems to be busted off from the lower control arm. Where the bolt goes through the control arm the steel is busted. It appears that there is a bolt that goes through the lower arm which I'm hoping is what I can replace without replacing the whole lower arm just to replace the endlink. I couldn't get a good look at it due to location. Was wondering if anyone on here had any issues like this or knows the setup of the lower arm?