DIY oil pressure sensor install
Results 1 to 3 of 3

This is a discussion on DIY oil pressure sensor install within the Request a Tutorial/DIY forums, part of the Tutorials & DIY category; to my knowledge you screw the oil sandwhich between the oil filter and the block run the wiring down to ...

  1. #1
    Registered User
    Join Date
    May 2012
    Posts
    21

    DIY oil pressure sensor install

    to my knowledge you screw the oil sandwhich between the oil filter and the block run the wiring down to the sandwhich and thats it?
    tell me if im wrong!! thanks

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Moderator rage-wrx's Avatar
    Join Date
    Aug 2010
    Location
    Yonkers/NYC
    Posts
    10,767
    I Support ClubWRX
    That or use the stock sender with a galley plug.
    T0ny
    2011 WRX
    2012 FXT

    The Big 2011/2012 Mod Thread


    Ooh,hang on. That is the throb of a turbocharged flat four engine. A sound which,all over the world,heralds the imminent arrival of a moron - JC.

  4. #3
    Registered User jd92677's Avatar
    Join Date
    Jul 2010
    Location
    Cincinnati
    Posts
    2,136
    I used the stock location with an adapter. Figured I would get the most accurate reading there.
    Stink eye mob #727
    2011 WRX DGM Hatch, Protuned Stage 1

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •