I sold my RS the other day and decided to part out the 03 wrx engine with 23k(carfax miles) and misc. parts I had laying around. The engine was purchased in 2004 from a dishonest guy who said everything was good with the intention of dropping it in a previous swap I did. I dropped the engine in a and it had a spun rod bearing, so I removed it and purchased another ej20 from Japan direct of Raleigh NC.
I chose to tear this engine down and rebuild it, but I got busy so the engine never got put back together. The heads were cleaned and inspected by T-hoff machshop of Raleigh NC and I had ferrea std. SS valves shimmed, installed and clearances checked Heads r sold!!! . They r ready to be installed...The engine ran awesome with the exception of the spun rod bearing, which only stayed in the car for 2 days before dropping another one in. The engine was extremely clean when I bought it and even cleaner after I installed it. I have a list below of what I have and pics hosted by photobucket...
THIS IS WHAT I HAVE LEFT
OEM Subaru EJ205 short block case. Bare block and does not have include crankshaft, pistons, rods, or bearings.
1. ej20 block clean and inspected with no damage$250 obo shipped
2. crankshaft (machined .10 .10 rods/mains) Will require oversized bearings $150 shipped
5. stock crank pulley $15 shipped
10.stock RS fuel pump $15 shipped
11.stock WRX f/p $25 shipped
12.oil pump $55 shipped
13.water pump with tubes and hoses $55 shipped
14.stock motor mounts $35 shipped
15.oil pan with pickup all bolt and new oil plug $40 shipped
16.radiator overflow with cap $15 shipped
17.intake manifold with all sensor and vac tubing $200 shipped
18.dip stick and housing $12 shipped
20.used timing belt tensioner from motor before teardown $15 shipped
22.stock exhaust manifold $50 shipped
23.stock uppipe with egt sensor $30 shipped
24.stock midpipe with cats and $50 shipped
32 short throw shifter $10 shipped
PICS ARE AT LINK