S13 t-70 sr20-det for sale and/or trade
Results 1 to 2 of 2

This is a discussion on S13 t-70 sr20-det for sale and/or trade within the Personal For Sale & Wanted forums, part of the ClubWRX.net Marketplace category; so i started my s13 project about 8 months ago and its been a long process, but its turned out ...

  1. #1
    Registered User
    Join Date
    Dec 2007
    Posts
    9

    Exclamation S13 t-70 sr20-det for sale and/or trade

    so i started my s13 project about 8 months ago and its been a long process, but its turned out i don't have enough time to finish it so i figure its time to get rid of it. It's a 1991 240sx coupe se that i converged the front end into a s-13 silvia, the fenders and hood are banged up but the bumper is fine the center piece has a crack on the right side of the word silvia. I swapped a JDM SR20-det into it the 2nd week i had it started it up and it ran fine for a couple of hours until i started taking it apart to put on the performance parts, it hasn't been started since then but i know the motor runs good, reason it hasn't been started is because i haven't had the time to get a tune put on the EMS. It has a long list of performance up grades

    to start off it has a Aem ems with uego
    aem boost siloned(boost controller)
    g35 throttle position sensor
    act six puck sprung clutch
    b&m short shifter
    auto meter gauges: boost, oil pressure, water temp, and fuel pressure
    3 gauge pod pillar and two independent gauge pods on the dash
    wire ground kit
    new intercooler with piping
    aluminum radiator with new hoses
    Tial 38mm waste gate with 11 pnd spring
    custom top mount turbo manifold with reenforced welds
    T-70 v-band oil fed turbo
    new oil catch can
    2.5in down pipe into a full 3in exhaust(needs flex pipe welded on)
    greddy replica intake anifold
    with top feed fuel rail
    nismo fuel pressure regulator
    72pnd injectors from jgy
    new fuel filter
    walboro 255 fuel pump
    slim line radiator fan (no clutch fan)
    brand new HKS ssq2 bov
    Polyurethane mounts from JGY

    thats most every thing thats in it there probably a few things missing from the list. there are a few minor thing that do need to be done, the interior need to be finished being put back in it, it doesn't have a carpet in it, the dash needs to be replaced the gauges need to be finished getting wired, the oil line into the turbo needs to be siliconed (forgot to do it when i put it on so it leeks a little), other than the gauges 98% of the wiring is done, the ems is completely wired up though, im asking $9,000 OBO OR WILL TRADE i only have 3 pics at this moment but i will up load more pics later this week. ive invested alot of time and money into this car and im sad to see it go but i just dont have time for it. im located in greensboro, nc

    http://i268.photobucket.com/albums/j...t/IMG00065.jpg
    http://i268.photobucket.com/albums/j...t/IMG00066.jpg
    http://i268.photobucket.com/albums/j...t/IMG00067.jpg
    http://i268.photobucket.com/albums/j.../MyPics005.jpg
    http://i268.photobucket.com/albums/j.../MyPics006.jpg

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User evokiller06's Avatar
    Join Date
    Sep 2008
    Posts
    8
    Pics dont work???

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •