Boost gauge fittings
Results 1 to 3 of 3

This is a discussion on Boost gauge fittings within the Interior Mods forums, part of the Tech & Modifying & General Repairs category; I'm moving my boost gauge from my steering column to a center pod. I can't get this little part off ...

  1. #1
    Registered User qoncept's Avatar
    Join Date
    Oct 2003
    Location
    Montgomery, AL
    Posts
    1,204

    Boost gauge fittings

    I'm moving my boost gauge from my steering column to a center pod. I can't get this little part off the hose so I need to replace it, can anyone tell me where to get it (hopefully in town) ? Thanks!
    Attached Thumbnails Attached Thumbnails 150-851.jpg  

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User 04blkWRX's Avatar
    Join Date
    Jul 2003
    Location
    NNJ
    Posts
    721
    You can get ferrules at McMaster-Carr but I think it would be easier to just cut the tube back a little and put a new fitting on the end. It only sees pressure to 15psi or so, so an instant-on fitting would be fine. Check your Home Depot (or similar) or a plumbing supply store.

  4. #3
    tan
    tan is offline
    Thinking Man's Engine tan's Avatar
    Join Date
    Dec 2001
    Location
    Wharton, NJ
    Posts
    3,014
    www.ecstuning.com

    $5
    helps prevent the kink right before the gauge

    I also have an extra plastic fitting lying around also
    Attached Thumbnails Attached Thumbnails 2154_x450.jpg  

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •