Gauge Advice Please

[AJAX]

I purchased the oem gauge pod and two of the three gauges (boost & Volts) I do not have the oil pressure gauge for the third gauge. That was ok because I thought I would just install a clock in the third gauge spot. The problem is that I dont have the faceplate for the gauges. I thought I may be able to cut some holes through some abs plastic but now I see that the faceplate is actually gonna be a real pain to make. Im looking for any suggestion to mount two of the three oem gauges and a 2 1/16 clock into the oem pod. If the 2 1/16 clock wont fit Ill put a 45mm egt gauge in instead. Any suggestions would be welcome.

Peter

[bambams247]

Where did you get the clock gauge, got a link? What does it look like. thanks!

[Ronin2121]

Peter,

I have Autometer Phantom 2 1/16 gauges (6 of them). I have a boost, A/F (useless), and a clock in my oem pod. I used a blank piece of trim that the stereo places use and cut the holes. Not hard to do and looks pretty good.

Good luck,
Ronin

[AJAX]

Bambam...clock gauge is available from Autometer and VDO

Hey Ronin....I think the problem for me is that I have 2 oem gauges at 45mm and the clock I want is 52mm. I want the clock in the middle and I was looking for some kind of template for the faceplate to get me started. I am not very mechanically inclined and it would take me forever to do. Help Me!!!!! Please!!!