Wiring an engine start button into Impreza

[madser]

Hello ppl.
Am new to this site, looks good!
Hoping to make new buddies here and chat lots about Imprezas!!!!!

Can you help me ???
I recently purchased an engine start button kit for my 99 sti type r. Problem is there are 4 wires coming outta the ignition barrel and from the relay I got in the kit I need to connect only two here, but which two??
Has anyone ever done this or know of a diagram I could access, any help getting this sorted Id appreciate...

Ta

Ken

[mclovin01]

Constant 12V+ White Ignition Switch Harness
Starter White/Black Ignition Switch Harness
Ignition Green Ignition Switch Harness
Accessory Yellow Ignition Switch Harness

You need to splice into the starter and ignition wires, If you do that it will work. I hope this helps you.

[madser]

Thanks mate, much appreciated

[mclovin01]

No problem let me know how it works.

[madser]

Cheers mclovin, thats fully wired now and ON the button as they say!!!
Next to go in is the turbo timer.............
Ill take photos when the project is done n post up...

Cheers

[mclovin01]

Good deal. I just put a turbo timer and remote starter in my 2002 wrx a few weeks ago its not to hard of a install. Good luck on the turbo timer install.

[madser]

Hey mate, I purchased a type 0 hks turbo timer for it, do ya know how to go about fitting it???

[mclovin01]

Hey mate, I purchased a type 0 hks turbo timer for it, do ya know how to go about fitting it???

What wires have to be hooked up on the turbo timer.
let me know and I will try to help you out.

[madser]

Theres a safety system connection to be done, a grey wire which runs to the hand brake cable,and a black (gnd?).I have the subaru harness, am wondering does this connect to a pink colour one off the car?

[mclovin01]

Theres a safety system connection to be done, a grey wire which runs to the hand brake cable,and a black (gnd?).I have the subaru harness, am wondering does this connect to a pink colour one off the car?

Easy. I sure the subaru harness gos to the pink one on the car.
Know the gray wire run it up through your center console and splice in to the wire coming off of your e-brake switch. As for the black ground just put a ring terminal on it and ground it out underneath a bolt.

Good luck I hope this helps you out.