gauge wiring question
Results 1 to 3 of 3

This is a discussion on gauge wiring question within the Interior Mods forums, part of the Tech & Modifying & General Repairs category; I need to get the wires through the firewall, and fish them up the pillar. What is the easiest way ...

  1. #1
    Registered User svynx's Avatar
    Join Date
    Aug 2008
    Location
    Hellam, pa
    Posts
    70

    gauge wiring question

    I need to get the wires through the firewall, and fish them up the pillar. What is the easiest way to do this?
    Cheers
    Owner of the Budget Baller
    Bugeye Mafia #201
    Current mods: CAI, SPT exhaust, D-specs w/RCE Yellows, F/R Group N top hats, JDM lip kit, LWFW, F/R sways and endlinks, morettes, tuned at Agile Auto (10/9/10)
    Next project: EvoIII-16g, pnp, 850 injectors, fuel pump, and a little secret.

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User vttk_mig69's Avatar
    Join Date
    Jan 2008
    Location
    Sheboygan, WI
    Posts
    527
    find a grommet that will fit the wires or get a new grommet from a hardware or auto store and drill a new hole. (if ur up to it)

  4. #3
    DUB
    DUB is offline
    Registered User DUB's Avatar
    Join Date
    Jul 2007
    Location
    SLT, CA
    Posts
    3,176
    Yes, use a grommet otherwise the wires will fray against the side of the hole you string them through.

    If you are talking about the easiest way to pull the wires up through the dash, that would be a cable puller, seen below. You press that button at the top and a little grabber open and holds the wire while you pull it through. Or, use the poor mans cable puller and use a wire clothes hanger and tape the wire to the end of it.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •