So I've been planning for awhile getting a wideband O2 Setup in my car but the thing that's been bothering me is to where I would put the gauge since I already have 3 gauges up on my pillar and really don't want to buy anopther pod...

What I was planning on doing is chucking the oil pres gauge and going for a center mounted gauge up by the stock clock... but that's just wasting the oil pres gauge. What I was planning on doing was setting up a wideband controller using the JAW controller (http://www.14point7.com/JAW/JAW.htm), so that the install would be cheap and just as good if not better than most widebands out there since it has the O2 vs rpm datalogging capability. then I got looking into there site and remembered they had a digital readout gauge as well...

Think about it... A/F ratio gauge in stock clock location... it would look damn near stock and would function perfect. Just use some epoxy to stick it up there cut out the stock housing to make it fit okay and your good!