How to remove release bearing?
Results 1 to 2 of 2

This is a discussion on How to remove release bearing? within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; I'm installing a new engine and it says to remove the release bearing from the clutch plate with a screw ...

  1. #1
    Registered User MNBodyMan's Avatar
    Join Date
    Sep 2003
    Location
    Minnesota
    Posts
    37

    How to remove release bearing?

    I'm installing a new engine and it says to remove the release bearing from the clutch plate with a screw driver and then intall it onto the tranny shaft. I can't figure out how to get it off the pressure plate at all. Anybody know how? I'm confused about where to pry at it with the screw driver. In the picture do you pry directly after the bearing, or where you can see kind of a sline pattern in there? Thanks for the help in advance


  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User
    Join Date
    Feb 2003
    Posts
    33
    Don't pry it off, instead put the screwdriver between the bearing and pressure plate and twist it...it should pop out easily.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •