Ready to Seafoam....and a question
Results 1 to 3 of 3

This is a discussion on Ready to Seafoam....and a question within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; So I've got my 2002 WRX grocery getter, and I'm ready to do a few things, including seafoam the beast. ...

  1. #1
    Registered User pfsquirrel's Avatar
    Join Date
    May 2008
    Location
    NJ
    Posts
    44

    Question Ready to Seafoam....and a question

    So I've got my 2002 WRX grocery getter, and I'm ready to do a few things, including seafoam the beast. I'm prepared to run some through the cylinders and the gas tank only. I'm not too fond of putting solvents in my oil lines, especially since I'm paranoid that loosening gunk might cause a leak somewhere.

    140,000mi on it, just changed the belts, and I'm preparing to change the O2 sensor. I figure it's better to run some seafoam before I put a brand new sensor in, just to avoid any foul-ups.

    Anyhoo, I've searched around for seafoam posts, and it's the same thing over and over. "i love it", "it works" etc.

    My real question is, which vacuum line should I use, and can you post a pic highlighting which hose? I've heard the hose for the compressor bypass valve is a good one, but I'm not sure which one it actually is.

    Thanks!

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Registered User
    Join Date
    Jan 2005
    Location
    Canada B.C.
    Posts
    1,393
    '02 WRX 4EAT, 311,000KMs/194,500Miles, Sold. Best car I ever had. '09 STi stage 1, hope this one will be good too...

  4. #3
    Registered User pfsquirrel's Avatar
    Join Date
    May 2008
    Location
    NJ
    Posts
    44
    Alrighty, I figured that was it. Thanks!

    Now to get the camera out...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •