Front o2 sensor "not ready"
+ Reply to Thread
Results 1 to 3 of 3

This is a discussion on Front o2 sensor "not ready" within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; So i replaced the front o2 sensor on my car with a denso sensor. I went to get my emissions ...

  1. #1
    Registered User d_Ziggy_2000's Avatar
    Join Date
    Jun 2010
    Location
    Seattle(ish)
    Posts
    595

    Front o2 sensor "not ready"

    So i replaced the front o2 sensor on my car with a denso sensor.
    I went to get my emissions tested but it wasnt ready.
    they told me to do a drive cycle that they suggested which i did then went to test again and once again failed.
    I called subaru dealership and they told me to do a different drive cycle and i also did one according to forums on here as well and after 300 miles the sensor is still "not ready"
    I have now expired tabs and am not sure what i should do.. any suggestions??
    '88 Sub Justy *Rock in oil pan killed on freeway
    '87 Honda Civic *Bad pistons (to lazy to fix)
    '85 Nissan 200sx *Blown engine drifting
    '00 Sub Outback *Mother literally stole
    '92 Toyota Tercel *Hated it
    '02 WRX '07 kawasaki ninja. * current

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    OMG WTF MainFrame's Avatar
    Join Date
    Sep 2002
    Location
    Texas, United States
    Posts
    8,732
    I Support ClubWRX I Support ClubWRX
    If you have a Tactrix cable you can use it to set the readiness of the sensors..

  4. #3
    Registered User d_Ziggy_2000's Avatar
    Join Date
    Jun 2010
    Location
    Seattle(ish)
    Posts
    595
    well i had my buddy come over cuz he had kind of the same problem for his MR2.. and found out that one of the main cables going to the battery.. not the one to the engine but the other one (power for ecu and sensors and stuff i think) was so corroded that he barely pulled on it and it snapped off.. pretty sure that is what the problem was. cuz now plugging in my computer with the tactrix cable, i'm hitting about 15.3lbs of boost. (is that to high?)

    if that doesnt work, how do i set the rediness of those sensors?
    '88 Sub Justy *Rock in oil pan killed on freeway
    '87 Honda Civic *Bad pistons (to lazy to fix)
    '85 Nissan 200sx *Blown engine drifting
    '00 Sub Outback *Mother literally stole
    '92 Toyota Tercel *Hated it
    '02 WRX '07 kawasaki ninja. * current

+ Reply to Thread

Quick Reply Quick Reply

Register Now

Please enter the name by which you would like to log-in and be known on this site.
If you do not want to register, fill this field only and the name will be used as user name for your post.

Please enter a password for your user account. Note that passwords are case-sensitive.

Please enter a valid email address for yourself. We strongly suggest that you stay away from using aol, yahoo, msn, and hotmail accounts. Sometimes the mail server blocks the emails from our server. As a result you will not receive any notifications including the confirmation email.

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.


Posting Permissions

  • You may post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •