Airbag Module Reset / Code Issue
Results 1 to 2 of 2

This is a discussion on Airbag Module Reset / Code Issue within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; Hey guys, Iv'e got an 03 WRX that has been a pretty great car so far, lots of small mods ...

  1. #1
    Registered User
    Join Date
    Mar 2011

    Airbag Module Reset / Code Issue

    Hey guys,

    Iv'e got an 03 WRX that has been a pretty great car so far, lots of small mods done to it.

    I've got a problem that has been perplexing me however. When I purchased the car the airbag light was on, I check all the airbags are in place and read out as not-blown with the DVOM. Was doing some reading and apparently when the airbags do blow the module can go with it, so pulled the center console and checked the p/n on the module, they keep coming back for a 05 STI.

    So I found an 03 Airbag module on ebay and installed it today, pulled the diagnostic connecter from the dash and did the pin read/reset trick, I can get the light to reset but as soon as you turn the key off and back on the light does not go off.

    The codes I have are 61 and 62 both are for the side seatbelt pre-tensioners which are reading fine with the DVOM and have not been deployed.

    Any help with this is much appreciated, the nearest subaru dealer is 3-4 hrs away and I would like to DIY this one if at all possible.


  2. Remove Advertisements

  3. #2
    Good news, everyone! xxxxxxxAnub1s's Avatar
    Join Date
    Jan 2005
    Eh, whaaaaa?
    I Support ClubWRX
    Have you checked the SRS connectors under the seats? One may have been disconnected for whatever reason.
    Hawk-Eye Alliance #727 N.E.R.D #

    Your nighttime volunteer of near-useless information.
    Good news, everyone!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts