Traction control after steering rack bushings

[Van-Van]

I just installed the whitline steering rack bushings. Now my tcs and hill assist lights are on. Any ideas?

Sent from my Droid using Tapatalk

[Anub1s]

Searching around, it appears the people with this problem seem to have misaligned the input shaft upon reinstallation. Is your steering wheel off at all when driving straight?

[Van-Van]

No, its straight as far as I can tell. I mis-marked it, so I kinda had to eyeball it, bit the few miles of driving I did were straight.

Sent from my Droid using Tapatalk

[Anub1s]

No, its straight as far as I can tell. I mis-marked it, so I kinda had to eyeball it, bit the few miles of driving I did were straight.

Sent from my Droid using Tapatalk

Gotcha, it seems that even being off by a small amount can cause issues though. Others have reported needing to change otu the clock spring assembly in their steering columns due to a ribbon in there having been torn because of a misalignment. Hopefully your issue is not as bad as that, but you may want to get it professionally aligned.

[Van-Van]

Got it, thanks.

Sent from my Droid using Tapatalk

[EvoEatr]

You might have a steering angle sensor code in there, as mentioned even a slight misalignment can throw a code, I have seen it many times...