tightening sequence nuts in the turbo to downpipe sti 2009
Results 1 to 3 of 3

This is a discussion on tightening sequence nuts in the turbo to downpipe sti 2009 within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; i just installed my cobb downpipe, i tight those nuts on the turbo to downpipe about 60 ft-lbs. i just ...

  1. #1
    Registered User wrx shan can's Avatar
    Join Date
    Jan 2010
    Location
    canada
    Posts
    1

    tightening sequence nuts in the turbo to downpipe sti 2009

    i just installed my cobb downpipe, i tight those nuts on the turbo to downpipe about 60 ft-lbs. i just want to know if it is ok that tightening sequence those nuts?

  2. Remove Advertisements
    ClubWRX.net
    Advertisements
     

  3. #2
    Banned
    Join Date
    Dec 2003
    Location
    Dallas, TX / Sterling, VA
    Posts
    6,629
    I Support ClubWRX
    Do it the same way you bolt a wheel on.

  4. #3
    Registered User EvoEatr's Avatar
    Join Date
    Aug 2008
    Location
    Kennett Square, Pennsylvania
    Posts
    1,839
    Quote Originally Posted by wrx shan can View Post
    i just installed my cobb downpipe, i tight those nuts on the turbo to downpipe about 60 ft-lbs. i just want to know if it is ok that tightening sequence those nuts?
    Personally Ive replaced many many downpipes and I usually (if the bolts are not stripped due to heat and rust) just run them in with my 3/8 impact..Of course spec for the stock down pipe nuts is around 30 ft-lbs....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •