Put the car in test mode, and turn the key to the "ON" position.
The BCS should "click"
This is a discussion on how do you know if your boost solenoid is bad? within the General Maintenance, Troubleshooting & Accidents. forums, part of the Tech & Modifying & General Repairs category; Is there a way to check you boost solenoid or do you know just by your boost? I have an ...
Is there a way to check you boost solenoid or do you know just by your boost? I have an 03 wrx only running 7.25psi and i did a boost leak check yesterday and found nothing. I heard it could be the bcs but i dont know how to check. Any advice is great!
Josh
2003 Subaru Wrx Vf39'd
Bugeye mafia #300
Sponsored By: WRXPro.com
Put the car in test mode, and turn the key to the "ON" position.
The BCS should "click"
2005 WRX STi (Mods | Virtual Dyno)
Resident Tuner @ WTF Tuning, LLC
"Never trust anything that bleeds for a week and lives ..."
UNYSOC
how do you turn the car to test modebut seriously
Josh
2003 Subaru Wrx Vf39'd
Bugeye mafia #300
Sponsored By: WRXPro.com
i'm not sure if its the same on older models but there should be two green plugs under the steering column
desiree
your friendly, neighborhood subaru girl
06 impreza wrx tr: cobb stage II - protuned by STi_Mikey!
hawk-eye alliance #11:11 // wingl3ss @ll!ance #17 // lvl 80 N.E.R.D.
I think his hoses are hooked up wrong.
Josh
2003 Subaru Wrx Vf39'd
Bugeye mafia #300
Sponsored By: WRXPro.com
Alright now take a picture of the boost gauge itself... and the tubing that comes out of the back of it... show us where it's leading...
Bookmarks